Resource Data Management PR0018-PHI Guía de instalación descargar pdf (Pagina 8)

Warning

Please Note

The specifications of the product detailed on this

Set-Up Guide may change without notice. RDM

Ltd. shall not be liable for errors or for incidental

or consequential damages, directly and indirectly,

in connection with the furnishing, performance or

misuse of this product or document.

Ensure that all power is

switched off before

installing or maintaining

this product

Revision 2.7 Page 8 of 83

Mercury Plant Controller Installation Guide

Note 2: Several probe types are available, see Probe Type

Note 3: The Status LED is not present on older variants of the Plant controller hardware. If the status LED is

present and the Plant controller software is V1.7 or greater then Analogue inputs 1 to 3 are configurable either as a

4-20mA input or a 0-10Vdc input. If the above criteria is not met then Analogue inputs 1 to 3 are configurable as 4-

20mA inputs only. In software version 2.6 or higher there is the option to have 4-20mA, 0-5V and 0-10V Inputs and

4-20mA, 0-20mA, 0-5V and 0-10V Outputs

Setting up the controller

Set-up access to the controller can be achieved several ways

Through the front mounted buttons on the remote display

Direct access by PC via a USB connection

Direct access by a PC via an Ethernet Connection

Through the RDM Data Manager.

Set-up Mode

Set-up through front buttons

To enter set-up mode, hold the Enter and Down buttons together for approximately 3 seconds until the message

“Ent” appears on the display. Now press the Enter button again to enter the function menu. IO will be displayed.

Scroll up or down to go through the list. Alternatively use either a PC connection for configurations or load a

configuration from a memory-stick

Set-up Menu

Display

Option

Menu Item

seen in type:

Explained in Paragraph

View Input/Output States

All types

View Input/Output States

PArA

Set/view Parameters

All types

Set/view parameters

Unit

Set/View Probe Type & Units

All types

Set/View Units

Uni

Set Universal IO

All types

Universal IO

StA

Set Status Input Type

All types

Status Input Type

rLy

Inverts the relay function

All types

Set Relay Output

TyPE

Set/View Controller Type

All types

Set/view product type

rtc

Set/view Clock (rtc = Real Time

Clock)

All types

Real Time Clock

nEt

Set/view network configuration

All types

Network Configuration

bCSt

Broadcast (Pressures)

All types

Broadcast

SoFt

View software version

All types

USb

Save/Load onto USB device

All types

USB

OFSt

Temperature probe offsets

All types

Set Probe Offsets

ESC

Exit set-up mode

Recommended set-up method

It is recommended that this controller is set-up using a direct connection to a PC See Setup via a PC

If you are not connecting to a network and want to set up the controller through the buttons we recommend you use

the following order from the function menu.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 82 83

Comentarios a estos manuales

Sin comentarios

Resource Data Management PR0018-PHI Guía de instalación Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Los conmutadores de red Resource Data Management PR0018-PHI